HIKVISION iDS-TCM203-A - Application Mode Configuration; Smart Mode Configuration

User Manual of Network Traffic Camera revise
58
Chapter 13 Application Mode
Configuration
Purpose:
This chapter introduces the parameters configuration under different trigger mode.
The supported trigger modes vary according to the camera models.
Note: The following configurations are not supported by all camera models of this
series.
13.1 Smart Mode
In this mode, target capture and license plate recognition are trigger by internal live
video analysis.
Steps:
1. Go to Configuration > Device Configuration > Application Mode.
2. Select Application Mode as Smart Mode.
3. Select Total Lanes. Up to 3 lanes are supported.
Figure 13-1 Smart Mode Configuration
4. Select Capture Type. All and Motor Vehicle are selectable.