User Manual of Network Traffic Camera revise
25
for speed detection.
Steps:
1. Go to Configuration > Device Configuration > System Configuration >
Installation Parameters.
Figure 8-2 Installation Parameters
2. Set the installation parameters according to the actual conditions.
Installation height and horizontal distance can be set according to the actual
installation height.
Horizontal field angel and vertical field angel refer to the installation angel of the
camera. You can set the degrees manually according to the actual installation
angel.
3. Click Save to save the settings.
8.3 Configuring Serial Ports
Purpose:
Configure the RS-485 parameters and RS-232 parameters in this page.
The RS-485 ports are used to input signals related to traffic control. The number
of available RS-485 ports can be different according to different camera models.
The RS-232 port can be used in two ways:
• Parameters Configuration: Connect a computer to the camera through the
To Next Page
Loading...
