HIKVISION iDS-TCM403-A Configuration Manual

Steps
Note
●
Not all the applicaon modes support scene mode sengs.
●
The scene mode parameters vary with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Applicaon Mode .
2.
Select Applicaon Mode.
3.
Set Capture Type.
Motor Vehicle, Non-Motor Vehicle, and Pedestrian
The motor vehicles, non-motor vehicles, and pedestrians in the scene will be recognized and
captured.
Motor Vehicle
Only the motor vehicles in the scene will be recognized and captured.
Non-Motor Vehicle
Only the non-motor vehicles in the scene will be recognized and captured.
4.
Set Capture Mode.
Burst
It adopts the separate exposure, and is applicable to the
condion of viewing face pictures
clearly at night.
Note
In burst mode, if you enable weaving out of the lane and illegal lane change detecon, the
burst light will not on, but captures will be triggered normally.
Strobe
It adopts the frame
extracng, and the captured pictures share the same exposure
parameters with the video image. It is applicable to the condion of capturing license plates
only.
5.
Set Speed
Detecon Mode.
Radar
Speed detecon via radar.
Video
Speed detecon via video.
6.
Click Save.
1.5.5 Set Radar Parameters
Set radar parameters for speed detecon via radar.
Network Trac Camera Conguraon Manual
24

HIKVISION iDS-TCM403-A Specifications

General

Brand	HIKVISION
Model	iDS-TCM403-A
Category	Security Camera
Language	English