hilmor 1963826 - Setup and Installation Guide; Battery Installation; Power On;Off and Clear; Reset Settings Between Jobs

See hilmor.com for other languages.
5
Battery Installation:
1. Remove the battery cap at the back end of the hilmor Digital Adjustable
Torque Wrench.
2. Insert two AA batteries, with the + side facing into the battery compartment.
3. Put on the battery cap and twist to the LOCKED position.
4. When the battery is low, a notification will appear on the screen as a
battery icon.
Power On/Of and Clear:
1. Press to power on the hilmor Digital Adjustable Torque Wrench.
2. Press
again to ensure that the hilmor Digital Adjustable Torque Wrench
is cleared before use.
3. The hilmor Digital Adjustable Torque Wrench will shut o automatically after
four minutes to preserve battery life. Press
again to turn the hilmor Digital
Adjustable Torque Wrench back on.
Reset “Clear” Settings Between Completed Torque Jobs:
1. Press and at the same time to reset.
Unit Selection:
1. Unit of measure can be changed if the hilmor Digital Adjustable Torque
Wrench is UNLOCKED. See page 6 for instructions on unlocking.
2. Press
to scroll through the dierent units and then stop to select.
The hilmor Digital Adjustable Torque Wrench measures in four dierent
torque units:
• Newton-Meters (N-m)
• Foot-Pounds (ft-lbs)
• Inch-Pounds (in-lbs)
• Kilogram-Centimeters (kg-cm)
SETUP
INSTRUCTIONS