Need help?Do you have a question about the HiLook NVR-216MH-C/16P and is the answer not in the manual?
General| Model | NVR-216MH-C/16P |
|---|---|
| Video Input | 16-ch |
| IP Video Input | 16-ch |
| Decoding Format | H.265+/H.265/H.264+/H.264 |
| Incoming Bandwidth | 160 Mbps |
| Outgoing Bandwidth | 80 Mbps |
| Synchronous Playback | Up to 16-ch |
| HDD Slots | 2 SATA interfaces |
| USB Interface | 2 × USB 2.0 |
| Power Supply | 100 to 240 VAC, 50 to 60 Hz |
| Consumption (without HDD) | ≤ 15 W |
| Operating Humidity | 10% to 90% |
| Dimensions (W × D × H) | 385 × 315 × 52 mm (15.2 × 12.4 × 2.0 inch) |
| VGA Output | 1-ch |
| Audio Output | 1-ch |
| SATA | 2 |
| Max HDD Capacity | Up to 10 TB capacity for each HDD |
| Network Interface | 1 RJ-45 10/100/1000 Mbps self-adaptive Ethernet interface |
| PoE Interface | 16 independent PoE network interfaces |
| Supported Standard | ONVIF, ISAPI |
| Operating Temperature | -10 °C to +55 °C (+14 °F to +131 °F) |
Covers the initial power-up, shutdown procedures, and device activation.
Step-by-step guide for initial NVR setup via the configuration wizard.
Explains the process of adding and connecting IP cameras to the NVR.
Details how to set up recording schedules for continuous or event-based recording.
Explains setting up motion detection areas and triggering recording.
Guides on accessing and playing back recorded video files.
Instructions for exporting and backing up recorded video files.
Explains the fast method for exporting recorded files to backup devices.
Covers configuring motion detection zones, sensitivity, and response actions.
Defines actions taken when an alarm or exception occurs, e.g., notifications, output.
Covers basic network configuration like IP address, gateway, and DNS.
Explains setting up HiLookVision for remote access via mobile app or platform.
Guides on preparing newly installed hard disk drives for NVR use.
Offers solutions for common problems encountered with the NVR and cameras.
To Next Page
