Need help?Do you have a question about the hilscher netRAPID 90 and is the answer not in the manual?
Use as a communication module with host interface, preloaded.
Use without host, flexible pin assignment, requires netX license.
Illustrates all connections of the netRAPID 90 chip carrier.
Discusses companion and stand-alone solutions for typical applications.
Guidelines for integrating the netRAPID 90 into a host system.
Discusses thermal management and the necessity of a thermal pad.
Covers proper handling, storage, and soldering procedures for the device.
Details the 3.3V power supply requirements and connection.
Describes the two Ethernet MACs with integrated PHYs and supported protocols.
Details the UART interface pins and design recommendations.
Lists pin assignments for companion solution use.
Details the Serial Dual-Port Memory (SPM) host interface.
Covers implementing PROFIBUS-DP and DeviceNet interfaces.
Lists pin assignments for stand-alone solution use, allowing customer adjustment.
Covers general signals like Brown-out detection and MMIO signals.
Describes access to the netX 90's 12-bit ADC units.
Details the switches and buttons on the evaluation board.
Details how to use switches S600-A, B, C, D for configuration.
Lists and describes the various interfaces available on the evaluation board.
Details the X308 UART connector (DSub).
Details the X400 RJ45 Ethernet connector.
Use as a communication module with host interface, preloaded.
Use without host, flexible pin assignment, requires netX license.
Illustrates all connections of the netRAPID 90 chip carrier.
Discusses companion and stand-alone solutions for typical applications.
Guidelines for integrating the netRAPID 90 into a host system.
Discusses thermal management and the necessity of a thermal pad.
Covers proper handling, storage, and soldering procedures for the device.
Details the 3.3V power supply requirements and connection.
Describes the two Ethernet MACs with integrated PHYs and supported protocols.
Details the UART interface pins and design recommendations.
Lists pin assignments for companion solution use.
Details the Serial Dual-Port Memory (SPM) host interface.
Covers implementing PROFIBUS-DP and DeviceNet interfaces.
Lists pin assignments for stand-alone solution use, allowing customer adjustment.
Covers general signals like Brown-out detection and MMIO signals.
Describes access to the netX 90's 12-bit ADC units.
Details the switches and buttons on the evaluation board.
Details how to use switches S600-A, B, C, D for configuration.
Lists and describes the various interfaces available on the evaluation board.
Details the X308 UART connector (DSub).
Details the X400 RJ45 Ethernet connector.
General| Brand | hilscher |
|---|---|
| Model | netRAPID 90 |
| Category | Control Unit |
| Language | English |
To Next Page