What to do if liquid escapes from Hilti Water System pump?
If liquid escapes from the top of the Hilti Water System pump, it's likely that the valve disk is either dirty or defective. Try cleaning the valve disk. If the problem persists, it's recommended to have the unit repaired by Hilti Service.
Why does the safety valve vent too early in Hilti Water System?
If the Hilti Water System's safety valve vents too early, the safety valve is likely defective. In this case, it's recommended to have the tool repaired by Hilti Service.
What to do if the pressure gauge shows no tank pressure on Hilti Water System?
If the pressure gauge indicates no tank pressure in your Hilti Water System, the pressure gauge itself is likely defective. Have the power tool repaired by Hilti Service to resolve this issue.
How to troubleshoot Hilti Water System when it does not build up pressure?
If the Hilti Water System unit isn't building up pressure, several factors could be at play. First, ensure the pump is screwed on tightly. If it is, check the O-ring on the pump for defects, or that the sleeve is defective. If either of these parts are defective, have the power tool repaired by Hilti Service.
General| Brand | Hilti |
|---|---|
| Model | DWP 10 |
| Category | Water Pump |
| Language | English |
To Next Page
