3
3. Cartridges, accessories and fasteners
Fasteners
Ordering designation Application
X-DNI, X-ZF Nails with differing application profile for a wide variety of fastenings
X-SL Easily removable formwork nail for temporary fastenings
X-EDNI Magazined standard nails for efficient fastening to steel
X-CR Stainless-steel nails for fastenings in damp or corrosive surroundings
X-AL-H High-strength nails for fastening to steel and concrete of higher strength
X-FS The ideal fastener for positioning formwork
X-IE The ideal fastener for fastening insulation material to concrete, plastered solid
masonry and steel
X-SW Flexible washer fasteners for fastening insulating foils / sheeting to concrete and steel
23/36 mm Washers for Hilti nails: simple securing of joint seals, foils / sheeting and timber to
concrete and steel using the X-460 WH23/36 washer holder
X-(E)M/W/6/8 ... P8, Studs for bolted fastenings on concrete and steel
X-M/W10 ... P10
X-(D)FB Metal conduit clip for fastening conduits or cable ducts and insulated pipes (hot or
cold) for plumbing and heating
X-EFC Plastic conduit clip for fastening flexible electric cable ducts and water or heating
pipes (hot or cold)
X-EKB Cable clasp for fastening electric cables flat on ceilings and walls
X-ECH Bunched cable holder for fastening cables on ceilings and walls
X-JH For fastening electric cables in accordance with fire prevention regulations (LAR)
X-ET Fastener for plastic (PVC) electric cable trunking
X-CC Clip for securing suspended fastening systems using wires or chains
X-HS Suspension system with threaded connection
For further equipment contact your local Hilti organisation.
Magazine
MX 72 Magazine – For quick and convenient fastenings
Fastener guides
Ordering designation Application
X-460-F8 Standard
X-460-F8N15 15 mm width for improved accessibility
X-460-F8N10 10 mm width for improved accessibility
X-460-S12 Fastener guide for fasteners with a 12 mm steel washer – higher pull over values
X-460-F8SS Spall stop for 8 mm studs – reduces spalling
X-460-F10 For 10 mm studs and nails
X-460-F10SS Spall stop for 10 mm studs – reduces spalling
X-460-FIE For driving X-IE insulation fasteners
X-460-FIE-L For driving XI-FV and X-IE insulation fasteners
To Next Page
Loading...
Need help?
General
