Why does the Hilti Impact Driver rotation speed drop?
If the rotation speed of your Hilti Impact Driver drops considerably, it's likely due to a low battery. Charge the battery to restore its performance.
What to do if Hilti Impact Driver gets very hot?
If your Hilti Impact Driver or its battery gets very hot, it means that the tool is overloaded, and application limits are exceeded. Select a product that is suitable for the intended purpose.
What to do if Hilti SIW 22T-A 1/2" doesn’t work and 4 LEDs blink?
If your Hilti Impact Driver doesn’t work and 4 LEDs are blinking, it indicates the power tool was briefly overloaded. Release the control switch and then press it again to resume operation.
Why Hilti SIW 22T-A 1/2" doesn’t work and 1 LED blinks?
If your Hilti Impact Driver isn’t working and 1 LED is blinking, the battery is either too hot or too cold. Allow the battery to cool down or warm up to its working temperature.
Why does the Hilti SIW 22T-A 1/2" battery run low quickly?
If the battery of your Hilti Impact Driver runs low more quickly than usual, it could be due to a very low ambient temperature. Warm up the battery slowly to room temperature.
How to fix Hilti SIW 22T-A 1/2" when the control switch cannot be pressed?
If the control switch of your Hilti Impact Driver cannot be pressed, it's because the forward/reverse selector switch is in the middle position. Set the forward/reverse selector switch to forward or reverse rotation.
What to do if the Hilti Impact Driver battery is not heard to engage?
If the battery is not heard to engage on your Hilti Impact Driver, it's likely that the retaining lugs on the battery are dirty. Clean the retaining lugs.
General| Voltage | 21.6 V |
|---|---|
| Max Torque | 450 Nm |
| Chuck Size | 1/2 inch |
| Chuck Type | Detent Pin |
| Full Hammering Frequency | 3200 impacts/minute |
| Number of Gears | 1 |
| Battery Voltage | 22 V |
| Drive Size | 1/2 inch |
| Max Torque (in-lbs) | 3983 in-lbs |
| Blows Per Minute | 3200 BPM |
| No Load Speed | 2300 rpm |
| Impact Rate | 3200 impacts/minute |
| Speed | 0-2300 RPM |
| Weight (lbs) | 4.6 lbs |
Covers essential safety precautions for operating power tools, including work area and electrical safety.
Specific safety warnings related to the operation of drill/driver tools.
Provides extra safety measures pertinent to screwdriver functionality.
Guidelines for the safe use, charging, storage, and handling of Li-ion batteries.
A table listing common problems, their possible causes, and actions to take.
To Next Page
