With the bleed plug installled at the reservoir, you may now remove the syringe and knurled bleed fitting from the caliper. Re-install the T-15 caliper
bleed plug. Tighten to 2-4Nm.
Step 10:
Step 11:
Step 12:
Start filling the brake with new mineral oil by slowly pushing the syringe. Air bubbles may come out of the reservoir. Continue pushing fluid until you no
longer see bubbles coming out of the tube .(See 4d)
Remove the plastic bag or collection bottle, section of tube, and knuried bleed fitting from the brake lever reservoir. Re-install the T-15 reservoir bleed
plug. Tighten to 2-4Nm.
Step 8:
Step 9:
Wipe off any excess oil from the lever and caliper body.
Remove 2-Piston Bleed Block and reintstall the brake pads.
46
To Next Page
Loading...
