Assembly Instructions
◆ Handlebar Installation（4mm Hex Wrench）
Loosen the bolts on your bike stem.
Center your handlebars and rotate them to align to the marking pointed to in the below image.
Step 1:
Step 2:
Step 3:
Tighten bolts to handlebar stem, but don’t tighten completely as you may want to further adjust the angle later to align more precisely. Test the
positioning, and adjust the handlebar to your preferred angle. After determining the best position, completely tighten all the bolts on the stem.
8
NOTICE: In addition to angle,
the height of the handlebar
can be adjusted by adding or
removing the headset spacers
if needed. For those without
experience, we recommend
having a professional make
such adjustments for safety
reasons.
To Next Page
Loading...
