BLADE ATTACHMENT
Fasten blade to motor with provided screws, lock washers and
flat washers. Repeat procedure for remaining blades. Make sure
screws are TIGHT! Loose motor screws can contribute to
unnecessary hum during operation.
NOTE:
Cordless power screwdrivers are N
OT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
10
|
hinkley.com
Screws
Lock Washers
Blades
Flat Washers
NOTE:
Remove any rubber supports that are installed for
shipping.
To Next Page
Loading...
