3.1 Voltage Measurement
15
1
2
3
4
5
6
7
8
9
10
5
1. Make sure the instrument is OFF.
2. Connect the AC adapter to the instrument.
3. Plug the AC adapter into the power outlet.
See Section 2.1 "Connecting Power" (page 21) of Instruction Manual.
4. Insert the PC card.
See Section 7 "Saving Measurement Data" (page 113) of Instruction Manual.
5. Remove the terminal board cover.
• To avoid the danger of electric shock, never connect the
power line to which the measurement cable is connected to
this unit while the power line is live.
• Never apply more than 30 Vrms AC or 60 VDC between ana-
log inputs, or between analog inputs and chassis ground.
To Next Page
Loading...
