16
3.1 Voltage Measurement
Quick Start Manual
6. Using the supplied flat blade screwdriver, connect the measure-
ment cables to channel 1 on the terminal board.
Be sure that the polarity of the cable connection is correct.
See Section 2.2 "Connecting Measurement Cables" (page 25) of Instruction Manual.
Recommended Lead Wire
When connecting the input cable to a transducer, refer to the
instruction manual of the transducer and be sure to connect the
cable correctly.
7. Replace the terminal board cover to protect the terminal board, and
for safety.
8. Turns on the power switch.
See Section 2.3 "Powering On/Off" (page 31) of Instruction Manual.
9. Set the parameters of this instrument.
GND
8420-51
8422-51
8421-51
GND
Channel Number
Single-conductor: 0.14 to 1.5
mm
2
Stranded wire: 0.14 to 1 mm
2
AWG : AWG26-AWG16
5 mm
Single-conductor
Stranded wire
To Next Page
Loading...
