Hioki 8420-51 - Page 23

3.1 Voltage Measurement
19
1
2
3
4
5
6
7
8
9
10
5
If a file name has already been entered, the file is automatically
saved with that name. For continuous saving, a number is
appended to the file name.
❖See Section 14 "Text Entry Procedure" (page 225) of Instruction Manual.
If no file name has been entered, default file naming is used
([AUTO, AUTO0001], etc.)
❖See Section 7.5 "Automatic Data Saving" (page 133) of Instruction Manual.
Set the automatic saving to "Binary (Real time)."
Move the blinking cursor to the position shown.
Select "Binary (Real)."
Set the Save Mode to "Normal" and "Full."
One file is created for each measurement session. When the PC
card is full, saving ends.
❖See Section 7.5 "Automatic Data Saving" (page 133) of Instruction Manual.
Move the blinking cursor to the position shown.
Select "Normal."
Move the blinking cursor to the position shown.
Select "Full."