Hioki 8807-51 - Page 242

218
_____________________________________________________________________
11.3 Comment Screen (Printer)
______________________________________________________________
Flashing cursor
Flashing cursor
3. Move the flashing cursor to the position as shown in the
figure below and use the
buttons to display the
Comment Entry Screen.
4 Move the cursor to each character to be entered, and enter
the comment. Refer to Section 11.3.3 Text Entry Procedure
for the entry procedure.
Enter the logic channel comments in the same way.
Copying Comments
Move the flashing cursor to the position shown in the
figure. Pressing the
button then copies the comment
from the immediately above channel. Pressing the
button
again copies the comment from the channel above that.
Similarly, pressing the
button copies the comment from
the channel below.