Hioki 8807-51 - Page 82

58
_____________________________________________________________________
4.8 Extended Status Screen Setup (MEM)
______________________________________________________________
Flashing cursor
Flashing cursor
(3) Set the recording length.
Move the flashing cursor to
Shot
and set the recording
length using the
buttons.
When setting the recording length for Sequential Save, the
recording length setting (on the Status Screen) is
automatically set to the same length.
The variable recording length can be set. Refer to Section
4.3.3.
(4) Set the number of divisions
Move the flashing cursor to
Divide
and use the buttons
to make a setting.