Monitoring Temperature Changes
26
This section describes how to save data after measuring.
Two methods are available for saving measurement data to a CF card or USB flash
drive after recording: [Select & Save] and [Quick Save].
Press the SAVE key
and select [Select & Save] to set the saving data type and make
other settings.
[Quick Save] causes data to be saved immediately when the SAVE
key is pressed, according to the settings made beforehand.
In this case, we use the default
[Select & Save] method to save waveform data.
Refer to “Analysis” (p. 33) for analysis methods.
4 Saving Data After Measuring
1
2
Select
Apply
Displays the Save
dialog.
• To view waveforms on the HiLogger or
with the Logger Utility, set the [Format] to
[Binary].
• To save the span defined by the A/B cur-
sors, specify the span before pressing the
SAVE key (p. 35).
• To capture a screen image (screen shot),
display the screen to be saved, and select
[Screen Image] in the dialog that appears
when you press the SAVE key.
• You can confirm the saved data on the
File screen by pressing the FILE key (p.
37).
For long-term measurement, set the Auto-Save setting to [Waveform(realtime)] (p. 22).
When [Cont] is enabled, data recording is limited to the size of the HiLogger’s internal
memory.
To avoid data loss, we recommend using both the AC adapter and battery pack.
To Next Page
Loading...
