Make input channel settings on the CH screen.
CH1 Setting
1
2
Setting Example
Channel: CH1, Input: Heat, Range: 10 mV
Enter the sensitivity constant of the sensor.
The test report that comes with the Heat Flow Sensor
contains the sensor’s sensitivity constant. When the
sensitivity constant is set, the scaling of the corre-
sponding channel is automatically changed.
Set the display span as necessary.
(Example)
Sensitivity constant: 0.02421 mV/
W·m
-2
(Also enter a unit prefix, if neces-
sary.)
Select
Apply
CH2 setting
1
2
Setting Example
Channel: CH2, Input: Tc,K (thermocouple), RJC: Int
Activate the open-circuit detection and set the display
range as necessary.
The default settings for the non-
framed items can be left as-is.
Change those as needed.
Select
Apply
To Next Page
Loading...
