* External dimensions do not include protruding points such as screws and terminal block.
the work exceeds the load capability of this equipment or the electric screwdriver. If it
is being used correctly and the overload protection is actuated frequently, immediately
stop use, turn off the main power switch, remove the power supply cord from the outlet
and return the equipment to the supplying dealer.
●
If overheating occurs, turn off the main power switch, remove the power supply cord
from the outlet and allow the equipment to cool naturally. After cooling, if the unit over-
heats while being used again, immediately stop use, turn off the main power switch,
remove the power supply cord from the AC outlet and return the equipment to the sup-
plying dealer.
●
When tightening screws in plastics and other materials that store static electricity
easily, discharge any static electricity prior to starting work. If static electricity is not
discharged,itmaycauseamalfunctionduetostaticelectricityowingfromthetipof
the bit.
●
Do not expose to severe shock such as dropping.
●
Do not connect other makers' electric screwdrivers, except for HIOS inc., . This may
cause a failure.
●
When equipment will not be used for a long period, turn off the main power switch and
remove the plug from the power outlet.
●
Do not disassemble or modify the design of the equipment. This may cause a failure.
In this case, the warranty may be voided and you may not be able to get the equip-
ment repaired.
■
Specication
Power supply model number BLOP-STC3•CLT-70STC3
Primary
Input Power Supply AC100-240V
Fuse capacity
(Inside AC inlet)
3A/250V (one spare)
Power consumption 15W under no load
Secondary Output voltage
HI : 31V DC
2 stage
LOW
: 20V DC
Overload protection function included
External dimensions* (mm) 127(W) × 208(D) × 76(H)
Weight (kg) 1.8
AC cord length
AC100VSpecication:1.8m(Standard3L3P)
AC220Vspecication:1.8m(basedonspecication)
Attachments
Operator's manual 1 copy, one AC power supply cord
Crimp contacts, 8 pieces
- 4 -