Hisense AHM-080HCDSAA-23 User Manual

TCY12021017E
TCY12021017E
TCY12021017E
AIR-TO-WATER HEAT PUMP
Hi-Therma Split/Integra Outdoor Unit
AHW-044HCDS1
AHW-060HCDS1
AHW-080HCDS1
Hi-Therma Split Indoor Unit
AHM-044HCDSAA
AHM-060HCDSAA
AHM-080HCDSAA
Hi-Therma Integra Indoor Unit
AHM-044HCDSAA-23
AHM-060HCDSAA-23
AHM-080HCDSAA-23
Hi-Therma Monobloc
AHZ-044HCDS1
AHZ-080HCDS1
Date: March. 2023
Qingdao Hisense Hitachi Air-conditioning Systems Co.,Ltd.
Add.: No. 218, Qianwangang Road, Economic and Technological Development Zone, Qingdao, China
http://www.hisensehvac.com E-mail: export@hisensehitachi.com
Specications in this catalogue are subject to change without notice, in order that Hisense may
bring the latest innovations to their customers.
BASIC MODELS
Technical, Installation
and Service Handbook
AIR-TO-WATER HEAT PUMP
Hi-Therma
SERIES

Hisense AHM-080HCDSAA-23 Specifications

General

Brand	Hisense
Model	AHM-080HCDSAA-23
Category	Heat Pump
Language	English

Summary

1. IMPORTANT NOTICE

1.2 GENERAL SAFETY

Notice: Servicing shall be performed only as recommended by the manufacturer.

2. SAFETY

2.1 APPLIED SYMBOLS

Identifies special symbols used to clearly identify safety situations and messages.

8. Installation

8.1 Installation of Hi-Therma Split Indoor Unit

Provides instructions for installing the Hi-Therma Split indoor unit.

8.1.2 SAFETY

Outlines safety precautions during installation design and unit installation.

8.1.3 IMPORTANT NOTICE

Provides critical information to read before starting installation.

8.1.6 Installation of Hi-Therma Split Indoor Unit

8.1.7 PIPING WORK

8.1.8 SPACE HEATING AND DHW

8.1.9 ELECTRICAL AND CONTROL SETTINGS

Covers general checks, wiring, terminal board connections, and DIP switch settings.

10. Control function

10.1.1 Main function

10.1.2 Alternate function operation with priority

10.2 Space heating/cooling

Covers operation of Water Cycle 1 and 2 for space heating and cooling.

10.3 DHW

10.4 Swimming pool (SWP)

10.5 Auxiliary electric heater

10.6 Boiler combination

10.7 Solar combination

10.8 Water pump control

Explains the control of water pumps WP1, WP2, WP3 based on system configuration.

10.10 Input /Output /Auxiliary sensors

10.11 Test Run

Provides procedures for performing actuator and unit test runs.

1. Troubleshooting

1.1 Initial Troubleshooting

1.2 Troubleshooting Procedure

Provides a systematic procedure for troubleshooting issues.

1.3 Checking procedure for main parts