Hisense Hi-Dom User Manual

Figure3.10 Factory information interface of air condition adapter
“MAC ” here is “air conditioning Adapter ID”, it can be copied for use.
Repeat this operation to add all air conditioning adapters into Hi-Dom system
After all adapters are added and saved successfully, click <read time> to read adapter time, and
click <timing> for revision of adapter internal time. if air conditioning adapter is connected to the
computer properly, and “air conditioning adapter ID” is correct, <connection status> will display
<connected>, <timing result> will display <normal>; otherwise it will display <not connected>
and <abnormal>, in this case, please check the IP address settings, cable connections, switch
power supply and air conditioning adapter ID, etc.
3.4.2 Adding meter reading adapters
Enter <Check debugging> -> <electricity and gas meter adapter maintenance> page, as shown in
Figure 3.11, for the configuration process, please refer to air conditioning adapter adding.
Figure 3.11 Metering adapter maintenance interface
※The bus line number of meter reading is the actual wire number of electricity meters, i.e. the
numbering of the meter reading adapter, NOTE: the meter reading bus number shall not replicate
the bus number of air conditioning.
※Meter reading adapter ID is the unique identification for meter reading adapter, consisting of a

Hisense Hi-Dom Specifications

General

Brand	Hisense
Model	Hi-Dom
Category	Controller
Language	English