Hisense PureFlat RB22A2FSE User Manual

Leveling of appliance
0.4" - 0.6"(10 -15mm)
A
A
C
B
C
Adju
stable bottom
feet
Front roller
Rear roller
B
F
o
r s
u
f
f
i
c
i
e
n
t l
e
v
e
l
i
n
g a
n
d a
i
r c
i
r
c
u
l
a
ting
in the lower rear section of the
appliance, the bottom feet may need to
be adjusted.You can adjust them
manually by hand or by using a suitable
spanner.
To allow the doors to self-close, tilt the
top backwards by 0.4" - 0.6"(10 -15mm).
6
Note:
If required you may lay the refrigerator
on its back in order to gain access to
the base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.
Installing the handles
adjustable bottom feet
Before you use the appliance, you
have to install the handles provided in
the fridge chamber.
Not provided
Wrench (5/16")
Monkey wrench
Upper Hinge-Left
Thin-blade
screwdriver
Cross screwdriver
Allen Wrench (5/32")
Upper Hinge
Cover-left
Screw Hole Cover
right
Middle Hinge-left
Left stop Block
Left Door Stopper
Tools you will need:
Thin blade(utility knife e.g. )
Additional parts (in
the plastic bag)
The longer one is fridge door handle, the
shorter one is freezer door handle. Please
follow procedures below to install and
reverse the handle.
Take out the screw hole covers on the
doors, install the handle supports 1. Place
the handle 3 and 4 on the doors by fitting
the handle over the handle supports 1,
then fasten the screws 2 with 5/32" Allen
wrench (provided in plastic bag).

Hisense PureFlat RB22A2FSE Specifications

General

Brand	Hisense
Model	PureFlat RB22A2FSE
Category	Refrigerator
Language	English