Door racks
2. Open part ① on top of the
refrigerator body from right side and
then take down part ③ and part ④ on
the upper door in the same way. Take
down part ② and put it back to the
plastic bag.
③Upper cover of upper door
②Upper hinge cover (right)
①Upper cover
④Corner cover
3. Disconnect electrical connector①as
well as electrical connector② and then
take down part③.
Note: Please hold the upper door by hand
during step 4 to prevent door dropping.
4. Remove the screws ①, loose
wire②, and remove par③.
5. Remove the upper door and place it
on a smooth surface with its panel
upwards. Lever part①and part④ then
loose screws② , as shown in the
picture. Change handle③ to the right
side, then install screws②, part① and
part④ in turn. Loose screws⑦, detach
part⑥ and part⑤ t
hen install part⑤
and another part⑥ (in the plastic
bag)to the left side with screws⑦.Put
part⑥ just detached back to plastic
bag.
,
② Special self-tapping screws
③ Handle
① Handle covers
④ Screw hole covers
⑤ Door holder
⑥ Stop block
⑦ Self-tapping screws
6. Loose screws used to fix the middle
hinge and remove middle hinge. Then
remove the lower door.
1 2
3
3
2
1
Special flange self-tapping
screws
Earth wire
1 2
1
2 3
Hisense Refrigerator
6
①
②
③
part
To Next Page
Loading...
Need help?
General
