14. Exchange wires both in the left and
right slots of refrigerator body.
15. Move the upper door to appropriate
position, adjust part① and upper door,
Move the connecting wire② in the slot
of upper door from right to left， and
then fix part①and wire② by screws③.
(Please hold upper door by hand when
installing)
16. Connect electrical connector① in
accordance with step 3 and then
install part②(which is in the plastic
bag).
②upper hing e cove r(left )
①
17.Reverse part① by 180°and install it
onto the right corner of upper door，
then mount part②. (both of which are
taken down in step 2)
18. Take the reed switch out of the
coping block(part③ 6 in step 3)and
mount it on another block for use
(which is with mark “R” in the plastic
bag). Put the coping block just
removed back to the plastic bag.
19. ,
connector② , and then install part③ .
Install part ① connect the wire
20. Open the upper door, mount door
racks and then close it.
Note：
Be sure character side of reed
switch fits well with coping block.
1 2
1 1
3
2
Hisense Refrigerator
8
To Next Page
Loading...
Need help?
General
