Control panel
Starting up and temperature regulation
The temperature selector knob is located
on the top of the refrigerator compartment.
Setting “0” means
Off.
Clockwise rotate the knob to turn on the
appliance
Setting “1” means
Highest temperature, warmest setting.
Setting “7” (end-stop) means
Lowest temperature, coldest setting.
Normally we advise you select setting of 3 or
4, if you want the temperature warmer or
colder please turn the knob to lower or
higher setting accordingly.
Important! High ambient temperatures (e.g.
on hot summer days) and a cold setting
(position 6 to 7) may cause the compressor
to run continuously or even non-stop!
Reason: when the amb
ient temperature is
high, the compressor must run continuously
to maintain the low temperature in the
appliance
First use and Installation
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand new product, then
dry thoroughly.
Important! Do not use detergents or
abrasive powders, as these will damage the
finish.
Installation Positioning
Warning! Before installing, read the
instruction carefully for your safety
and correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
Insert the plug of the connection lead into
the plug socket with protective earth
contact. When the refrigerator compartment
door is opened, the internal lighting is
switched on.After the fridge has been
placed in position,wait for 5 minutes before
electricity is supplied.Don't store anything
until the temperature inside the fridge
becomes low enough.
28
Adequate air circulation should be around
the appliance, lacking this leads to
overheating. To achieve sufficient
Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor,
condenser) to prevent the risk of a fire,
follow the instructions relevant to
installation.
The appliance must not be locate close to
radiators or cookers.
ventilation, foll
ow the instructions relevant
to installation.
Any electrical work required to do the
servicing of the appliance should be
carried out by qualified electrician or
competent person.
This product must be serviced by an
authorized Service Center, and only
genuine spare parts must be used.
1)If the appliance is Frost Free.
2)If the appliance contains freezer compartment.
Service
Make sure that the mains plug is
accessible after the installation of the
appliance.
To Next Page
Loading...
Need help?
General
