Hisense RT641N4WFE1 - Drawer and Door Installation

13
,
Adjustable bottom feet
10-15mm
A
C
A
A
B
C
Adjustable bottom
feet
Front roller
Rear roller
B
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the
appliance, the bottom feet may need to
be adjusted.You can adjust them
manually by hand or by using a suitable
spanner.
To allow the doors to self-close, tilt the
top backwards by 10-15mm.
1. The freezer compartment is provided
with an upper drawer, a lower drawer ,
two trays and an ice box;
2. Open the freezer door; Pull up the
adjusting block (A) of the slide guides,
and pull out the freezer door drawer (A)
to the final position.
1. The freezer compartment is provided
with an upper drawer, a lower drawer ,
two trays and an ice box;
2. Open the freezer door; Pull up the
adjusting block (A) of the slide guides,
and pull out the freezer door drawer (A)
to the final position.
Disassembling the freezer drawer
Disassembling the freezer drawer
3. Take out the tray (B) by lifting it up in the
direction of the arrow.
4. Remove the lower freezer drawer (C) by
lifting it up.
Note:
If required you may lay the refrigerator
on its back in order to gain access to
the base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.