8
. Use the Allen wrench(provided in the
plastic bag) and cross-shaped
screwdriver to loosen the screws and
remove the middle hinge-right.
9. Change screw hole covers and screw
on middle cover plate from left to right
(as shown in figure below).
.
Install middle hinge-left (in the plastic
bag) .
10.
Transfer the upper door to the
appropriate position. Secure the
door level, make the middle hinge axis
into the lower hole of the upper door.
Install the hinge② (provided in the
plastic bag)by screws①. Please hold the
upper door by hand when installing.
11.Take out the connector from the hole
on the top left side.Then connect it with
the door switch on the upper hinge
cover-left.
Special flange screw
Upper hinge-left
①
②
①
②
Door switch
Electrical connector
12.Install the upper hinge cover② on
the left corner by screw①.
13.Open the upper door and install the
door racks and then close it.
Note:
If your appliance has handle, you have
to reverse handle by follow instructions
below.
Lever part① and part④
, then loose
screws②. Change handle③ to the right
side, then install screws②, part① and
part④ in turn.
①
①
②
②
Self-tapping screw
Upper hinge cover-left
①
②
③
④
①
②
Handle cover
Special screws
③
Handle
④
Screw hole cover
16
To Next Page
Loading...
