Installing Your N
Positioning:
Position
●
the appliance
of stoves, radiators,
Maximum performance and sa ty ar
guaranteed by maintaining t corr ct
indoor temperature for the class o unit
concerned as specified on t rating plat .
This appliance
ST. The appliance
if left at a temperature abov or b low t
indicated range.
Climate class
SN
N
ST
T
Appliance must not
Sufficient air must be allow d to circulat
in the lower rear section of
poor air circulation can affect p r ormanc
Built-in appliance
away from heat sources suc as stov s,
fires or heaters.
Installation instructions:
Before
installing, carefully r ad t
instruction in order to avoid a c rtain
number of problems.
This is
Dimensions of mounting slot
ew Appliance
rces
Maximum p r ormanc and safety are
guarant d by maintaining the correct
indoor t mp ratur or the class of unit
conc rn d as sp ci i d on the rating plate.
from SN to
i l t at a t mp ratur above or below the
to rain.
Su ici nt air must b allowed to circulate
in t low r r ar s ction of
appliance, as
poor air circulation can a ect performance
.
away rom at sourc s such as stoves,
Installation instructions:
installing, car ully read the
instruction in ord r to avoid a certain
Dim nsions o mounting slot
.
Follow the steps
guide provided.
Note:
Your product is design d and
for domestic household us only. T
product must
located and operated in accordanc wit
the instructions contained in
Instructions guide
Reversing the fridge
The side at which the door op ns can b
changed, from the right side (as suppli d) to
the left side, if the installation sit r quir s.
Warning! When reversing t door,
appliance must not be conn ct d to t
mains. Ensure that the plug is r mov d
the mains socket..
Tools you will need(
Philips Screwdriver &
Slotted Screwdriver
Note:
When required, tilt the refrig rator back
order to gain access to t bas , you
should rest
packaging or similar mat rial to avoid
damaging the backboard o t
refrigerator. To reverse t door, t
following steps are g n rally
recommended.
1. Stand the refrigerator uprig t. Op n t
door,
remove the upper hing cov r
and right).
Remove the low r scr w ol
cover for the cabinet.
hole cover for the door.
installation
Your product is designed and
built
or dom stic ous old use only. The
locat d and op rat d in accordance with
t instructions contained in
the User
T sid at w ic t door opens can be
c ang d, rom t rig t side (as supplied) to
t l t sid , i t installation site requires.
Warning! W n r v rsing the door,
the
applianc must not b connected to the
mains. Ensur t at t plug is removed
from
8mm)
W n r quir d, tilt t r frigerator back
in
ord r to gain acc ss to the base, you
on soft foam
packaging or similar material to avoid
damaging t backboard of the
r rig rator. To r v rs the door, the
ollowing st ps are generally
1. Stand t r rig rator upright. Open the
r mov t upp r hinge cover
(left
6