HISON WATERCRAFT
8
Always use smooth transitions between throttle positions as sudden acceleration and
deceleration may upset the handling of the Crosski.
Note: The throttle lever is spring loaded and should return to rest position (engine idle) when not
pressed.
Braking (Land Mode Only)
Your Crosski is equipped with hydraulically operated brake calipers and rotors on each wheel.
Dependent upon specification, your Crosski, will either be equipped with a single brake lever that
operates the brakes for all four wheels, or dual brake levers that operate the brakes for the front
and rear wheels independently.
Apply the brake levers smoothly with increasing pressure to slow or stop the Crosski.
Note: remember, the brake levers will only slow or stop the Crosski when it is being ridden on
land and has no effect when the Crosski is being used on water.
Parking Brake (Land Mode Only)
Do not ride with the parking brake applied, or apply the parking brake while moving; this could
result in loss of control and may damage the brakes.
The brake levers have a parking brake feature that allow the Crosski to be left unattended with
the brakes applied.
To apply the parking brake:
1. Squeeze the brake lever
2. Push the parking brake lock into position
3. Release the brake lever while holding the lock in position
4. If your Crosski has dual brake levers, apply the parking brake on the other brake lever.
NOTICE: It can vary depending on brake pad wear. Make sure the parking brake is fully applied to
secure the Crosski in place.
To Next Page
Loading...