HISON WATERCRAFT
30
7. Maintenance Requirements
Post-operation after your ride
If you operated on water, open the hull drain plugs and allow any water to drain.
Thoroughly wash the Crosski with fresh water to remove any mud off your vehicle, pay
particular attention to the water intake and jet nozzle.
If you operate on or near salt water, make sure the wheel arches, suspension components
water jet and wheel assemblies are thoroughly washed in fresh water.
Periodically remove the upper body panel and rinse the engine compartment with fresh
water using a hose.
General information
Failure to maintain the Crosski in accordance with the maintenance schedule and procedures
outlines in this Manual may make the Crosski unsafe to ride and invalidate the Warranty Policy.
The safety, reliability and performance of your Crosski will depend partly on how well it is
maintained. Maintenance is the owner’s responsibility and you must ensure that the appropriate
maintenance is performed when required and according to the recommendations specified by
Hison.
Scheduled servicing
Note: if the Crosski is operated primarily or frequently in very dusty condition or in low or very
high temperatures, more frequent servicing and different oil and coolant specifications may be
necessary.
Regular scheduled servicing must be carried out after every 50 hours of use by a Hsion
dealer.
Arranging a service
Give your dealer as much notice as possible for any service or repair so that a mutually
convenient time can be arranged. When contacting your dealer, provide as much information as
possible about any concerns you have with your Crosski.
To Next Page
Loading...