HISON WATERCRAFT
5
In warm temperatures the fuel tank may be pressurized, take care when removing the filler cap
as fuel vapors may be released.
NOTICE:
Recommended: if possible always refuel on land. With the Crosski stationary and the engine off,
slowly unscrew the fuel filler cap and allow the vapors to vent.
Note: A chain secures the fuel filler cap to the Crosski to prevent loss.
The filler tube accepts a narrow filler nozzle of the type found on pumps that deliver
unleaded fuel.
Fill the tank slowly until the filler nozzle cuts off the fuel supply. Do not attempt to fill the
tank beyond this point, or spillage could result due to expansion of the fuel.
When replacing the fuel filler cap, insert the retaining chain into the filler neck and tighten
the cap until it clicks three times.
Emergency Refueling
It is possible to overfill the tank if a fuel dispensing pump is not used (e.g. portable fuel
containers).
If, in an emergency, you have to refuel the Crosski from a source other than a filling station,
check the specification of the fuel before refueling, and be careful not to overfill.
ATTENTION: If you do have to refuel while on water, make every effort to avoid fuel spillage. Fuel
can be very damaging to a marine environment.
To Next Page
Loading...