To Next PageTo Next Page
Need help?Do you have a question about the Hitachi Koki C 10FSH and is the answer not in the manual?
General| Type | Sliding Compound Miter Saw |
|---|---|
| Voltage | 120V |
| Blade Diameter | 10 inches |
| Miter Angle Range | 0-52° |
| Arbor Size | 5/8 inches |
| Bevel Angle Range | 0-45° (Left) |
| Saw Blade Bore | 5/8 inches |
Essential precautions and warnings before operating or maintaining the power tool.
Definitions of 'WARNING', 'CAUTION', and 'NOTE' symbols for hazard identification.
Key safety guidelines applicable to all power tool operations, including guards, work area, and apparel.
Detailed safety rules specific to the operation of this power tool, covering mandatory practices and prohibitions.
Identification and labeling of all components of the Hitachi slide compound miter saw.
Description of typical uses and applications for the Hitachi slide compound miter saw.
Instructions for securely mounting the power tool onto a work bench.
Procedure for disengaging the locking pin used for shipping and storage.
Guidance on attaching dust bags, holders, stoppers, and vises for operation.
Essential checks including power source, trigger, blade, safety cover, and cord condition.
Performing a trial run and inspecting blade stability for safe and accurate cutting.
Instructions for correctly positioning the table insert for various cutting angles.
Procedure to adjust the saw blade's lowest cutting position to prevent damage.
Adjusting the saw blade's lower limit for cutting tall workpieces to avoid contact.
Ensuring proper sub fence positioning for stable cutting, especially for bevel cuts.
How to operate the power tool's trigger switch and lock-off button safely.
Instructions for mounting and using the vise assembly to secure workpieces.
Step-by-step guide for performing actual cutting operations with the saw.
Method for cutting narrow workpieces using a press cutting technique.
Technique for supporting and cutting large workpieces effectively.
Procedure for performing slide cutting on wide workpieces.
Steps for setting up and performing bevel cuts on the workpiece.
Steps for setting up and performing miter cuts on the workpiece.
How to perform compound cuts by combining miter and bevel angles.
Specific instructions and angle settings for cutting crown molding.
Method for cutting crown molding without tilting the saw blade.
Techniques for cutting soft materials like aluminum sash safely and effectively.
Instructions on attaching and emptying the dust bag for sawdust collection.
Step-by-step guide for safely installing the saw blade onto the spindle.
Procedure for safely removing the saw blade from the spindle.
Inspecting the saw blade and adjusting loose slide pipe components for safe operation.
Checking carbon brushes and motor condition for potential issues.
Ensuring tool safety by inspecting screws and verifying safety cover operation.
Procedures for storing the tool, replacing the Poly-V-belt, and lubricating moving parts.
Methods for cleaning the tool, including the laser marker window.
