To Next PageTo Next PageWhy does my Hitachi BD-W70PV drum stop and rotate repeatedly during spin?
If the drum of your Hitachi Washer stops and rotates repeatedly during the spin cycle, it's because the washing machine is trying to correct an imbalance in the drum. This is a normal operation and not a malfunction.
What to do if buttons do not work on my Hitachi BD-W70PV Washer?
If the buttons on your Hitachi Washer aren't working, it could be because: - The child lock is activated. Deactivate the child lock to regain control of the buttons. - You're trying to change settings while a program is running. In this case, you must wait until the program is finished.
Why is my Hitachi Washer not supplying water?
If your Hitachi Washer isn't supplying water, consider the following possibilities: - The water tap might not be turned on. Ensure the water tap is fully open. - The water supply hose may be frozen. Check the hose and ensure it is not frozen. - The water supply hose may be kinked or pinched. Straighten the water inlet hose to allow water flow.
Why does the displayed remaining time change on my Hitachi Washer?
The displayed remaining time on your Hitachi Washer may change due to these reasons: - If the load is unbalanced, the washing machine may prolong the washing time to correct the imbalance. This is normal operation. - If there is too much foam, the washing time may be extended to eliminate it. Use the appropriate amount of detergent to prevent this. - The remaining time is continually corrected and may change during the program. This is not a malfunction.
Why is there a lot of foam in my Hitachi Washer?
If you notice a lot of foam in your Hitachi Washer, it may be because you've used too much detergent. Try using the appropriate amount of detergent. The amount of foam can also vary depending on the temperature, level of soiling, and water hardness.
Why is there no foam or hardly any foam in my Hitachi Washer?
The amount of foam in your Hitachi Washer can vary depending on the temperature, level of soiling, and water hardness. Ensure you are using the appropriate amount of detergent. Also, avoid pouring detergent directly into the drum, as it may remain undissolved.
Why is there an odor in my Hitachi BD-W70PV?
An odor in your Hitachi Washer might be due to a couple of reasons: - Rubber parts may give off a smell when you first start using the washing machine. This smell should go away over time. - There may be mold, dirt, or detergent residue on the drum. Run the Tub Clean program to resolve this.
Why does fabric softener overflow in my Hitachi BD-W70PV?
Fabric softener might overflow in your Hitachi Washer because you've exceeded the maximum level of softener in the detergent dispenser. Avoid pouring in more than the max level of softener.
Why does my Hitachi Washer rinsing begin before spinning finishes?
If rinsing restarts automatically in your Hitachi Washer to correct imbalance in the drum, this is not a malfunction. It happens for safety reasons.
Why is there detergent powder residue in the detergent dispenser of my Hitachi Washer?
If you notice detergent powder residue in the dispenser of your Hitachi Washer, it could be because you're using too much detergent. Use the appropriate amount of detergent. Also, avoid pouring detergent into the dispenser when it's wet; wipe away any water before adding detergent.
General| Type | Front Load |
|---|---|
| Capacity | 7 kg |
| Spin Speed | 1200 rpm |
| Energy Efficiency Rating | A+++ |
| Dimensions (W x H x D) | 600 x 850 x 600 mm |
| Weight | Unknown |
| Product Type | Washing Machine |
| Spinning Capacity | 7 kg |
| Voltage | 220-240V |
| Frequency | 50 Hz |
| Material | Stainless Steel |
| Color | White |
