27
■
Make sure that the union nut between the water supply hose and main
unit is tightly screwed.
■
Turn the tap on to check if the water supply hose is properly connected
before starting. If it is loosely connected, water leakage may occur.
●
Drain hose
■
The drain hose should be placed higher than 60 cm above and not
higher than 100 cm above the fl oor.
If the drain outlet is lower than 60 cm,
a joint pipe is necessary (additional
part, sold at a specialist outlet).
Secure the drain hose to prevent from
slipping out from joint pipe.
Joint pipe
60~100 cm
■
Do not bend, twist, crush or pull out, bend or step on the drain hose.
Use the hose guide to prevent the drain hose from kinking.
■
Do not detach the drain hose from the rear panel of the washing
machine.
Drainage into a wash basin (Using the packed-in hose guide) :
- Secure the drain hose to prevent it from
slipping out of the wash basin.
- The wash basin outlet must not be sealed
by a plug.
- When water is being pumped out of the
washing machine, check that the water
drains away quickly enough.
Drainage into a siphon :
- Secure the connection point with 24-40
mm φ hose clip (Sold at a specialist
outlet).
How to Install the Washing Machine
To Next Page
Loading...
