Hitachi C7SB - Page 6

43. USE ONLY CORRECT BLADES IN MOUNTING. Do not use blades with
incorrect size holes.
Never use defective or incorrect blade washers or bolts.
44. A VOID CUTTING NAILS. Inspect for and remove all nails from lumber
before cutting.
45.00 NOT RUN THE SAW WHILE CARRYING IT AT YOUR SIDE.
SERVICE AND REPAIRES
All quality tools will eventually require servicing or replacement of parts due to
wear from normal use. These operations should ONLY be performed by an
AUTHORIZED HITACHI POWER TOOL REPAIR SHOP.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
POLARIZED PLUGS
To reduce the risk of electric shock, this equipment has a polarized plug (one blade
is wider than the other).
This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not change the plug in any way.
EXTENSION CORD
Make sure your extension cord is in good condition. When using an extension
cord, be sure to use one heavy enough to carry the current your product will draw.
An undersized cord will cause a drop in line voltage resulting in loss of power and
overheating. Table shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the
gage number, the heavier the cord.
MINIMUM GAGE FOR CORD SETS
Total Length of Code in Feet (Meter)
0-25
(0-7.6)
26-50
(7.9-15.2)
51-100
(15.5-30.5)
101-150
(30.8-45.7)
Ampere Rating
More Not More
Than Than
AWG
0-6
18 16
16 14
6-10 18
16
14
12
10-12 16 16
14
12
12-16
14 12 Not Recommended
5