Hitachi CG 31EBS - User Manual

CG 31EBS/CG 31EBS (L)
How to fi x throttle wire/stop cord
如何安裝油門線停止線
วิธีล็อกสายคันเร
่
ง/ดับเครื่อง
345
6715
3
5
C
Throttle wire/stop cord
Remove air cleaner cover. (Fig. 4)
Loosen and remove the screw from the throttle wire holder. (Fig. 6)
Connect the terminals of the stop cords coming out from the engine and shaft. (Fig. 5)
Hook the throttle wire end on the throttle of the carburetor.
Make sure that the throttle lever shown in the Fig.15 is set at the “idle” position.
Put the throttle outer end into the groove, and then cover it with the throttle wire holder and fi x the holder with the screw.
(Fig. 7)
Then, install the cleaner cover.
Fix the protection tube
which the stop cords and throttle wire are passing through, on the pipe with the hip pad. Then, as
shown in the fi gure, fi x the protection tube on the pipe and handle with the bands in the bag.
After fi xing, cut off the extra part of the band not to
obstruct the operation. (Fig. 3)
NOTE
○ If the protection tube is set apart from the handle or pipe, it will be caught by something during operation and it may
cause serious injury.
Do not set the protection tube apart from the handle or pipe.
○ After assembling the throttle wire,
if the wire length does not permit accurate return to the idle position, loosen the
screw in the throttle wire holder and readjust the position of the throttle wire whose outer end is fi xed in the groove.
Tighten the screw in the throttle wire holder to fi x the throttle wire
at the position at which idling is enabled.
000CG31EBSSheet.inddA000CG31EBSSheet.inddA 2009/10/019:53:512009/10/019:53:51

Summary

How to Fix Throttle Wire and Stop Cord

Remove Air Cleaner and Loosen Holder

Remove air cleaner cover and loosen the screw from the throttle wire holder.

Connect Cords and Hook Throttle Wire

Connect stop cords and hook throttle wire to carburetor at idle position.

Secure Throttle Wire and Reinstall Cover

Insert throttle wire end into groove, fix holder, and reinstall cleaner cover.

Route and Secure Protection Tube

Route protection tube on pipe/handle with bands, then trim excess.

Troubleshoot Throttle Wire Idle Position

Readjust throttle wire if it does not return accurately to the idle position.

Hitachi CG 31EBS Specifications

General

Brand	Hitachi
Model	CG 31EBS
Category	Brush Cutter
Language	English