Hitachi CH 14DSL - Battery Removal;Installation; Charging

28
English
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the
battery latch to remove the battery (see
Fig. 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its
polarities (see Fig. 2).
CHARGING
Before using the power tool, charge the battery
as follows.
1. Connect the charger’s power cord to the
receptacle.
When connecting the plug of the charger to
a receptacle, the pilot lamp will blink in red
(At 1-second intervals).
2. Insert the battery into the charger
Firmly insert the battery into the charger as
shown in Figs. 2, and 3.
Insert
Pull out
Handle
Latch
14.4 V Rechargeable battery
(For CH14DSL)
18 V Rechargeable battery
(For CH18DSL)
Fig. 2
14.4 V Rechargeable
battery
(For CH14DSL)
Pilot lamp
Insert
18 V Rechargeable
battery
(For CH18DSL)
Fig. 3
000BookCH14DSLChS.indb28000BookCH14DSLChS.indb28 2017/04/1713:48:352017/04/1713:48:35