FT-01 Finger Touch Unit - Quick Start Guide
INSTALLATION:
• Use one of three ways to attach/secure the
finger touch unit:
— Use four strips of double sided tape (A) on
flat, smooth surfaces
— Using magnetic sheet (B), affix three strips.
Secure on a fixed location i.e. metal
— Using two screws (C)
* Always use screws when installing at heights
of more than 6.5’ or 2m
• Use a Phillips-head screwdriver to remove the
cover
• Use the USB cable to connect the Finger
Touch to the Projector option port
CONFIGURATION:
1. Press the IWB button on the remote control to change to
WITH PC mode.
The unit must be mounted 2"- 4" above the
projected image, also allow 2" between the
projected image and the screen frame. You may
need to shrink your image. The image needs to be
between 60"- 80" diagonal.
The adjustment procedure using a Windows PC
is shown. If using a Mac PC, perform the same
procedure by referring to the U-Pointer manual
loaded in the DVD drive.
Models CP-TW2503 and CP-TW3003
Getting Started: Installation and Configuration
Please read pages 12-16 in the FT-01 User’s Manual for complete installation instructions
U-Pointer software should be installed on computer before Finger Touch Unit is used
This device can only be used with Hitachi LCD projectors. It cannot be used with
other projectors or for floor-mounted installation.
Double-sided tape (A)
3M
Pull out so that
3M is visible.
Red side
Magnetic sheet (B) Fixing screws (C)
or or
Projector's Ports
USB cable
Option port
2 Click the U-Pointer icon in the task tray of the
computer and select configuration
To Next Page
