Hitachi CP-WX8240 - Page 21

21
Click the [Apply] button to save the settings.
3.1 Projector Web Control - Network Settings (continued)
Item Description
Wired Setup Congures the wired LAN settings.
IP Conguration Congures network settings.
DHCP ON Enables DHCP.
DHCP OFF Disables DHCP.
IP Address Congures the IP address when DHCP is disabled.
Subnet Mask Congures the subnet mask when DHCP is disabled.
Default
Gateway
Congures the default gateway when DHCP is disabled.
DNS Server Address Congures the DNS server address.
Other Setup Congures other network settings.
Crestron e-Control
Set whether to or not to use Crestron e-Control
®
.
If you choose Disable, the Logon window of Projector Web
Control and not the selection window will be displayed at rst
of the Web Control.
3. Web Control
• The new conguration settings are activated after restarting the
network connection. When the conguration settings are changed, you must
restart the network connection. You can restart the network connection from
Network Restart on the main menu (
&41).
• If you connect the projector to an existing network, consult a network
administrator before setting server addresses.
• The WEP Key, WPA passphrase and SSID settings will not be set if the invalid
characters are used.
• The projector does not allow both wireless and wired LAN to be connected to
the same network. Do not set the same network address for both wireless and
wired LAN.
NOTE