16
1) Turn on the projector, and make sure that the projector image is on screen.
2) Press the MENU button on the remote control or the ▲/▼/◄/► buttons on
the projector to show the menu on screen.
3) Use the ▲/▼ cursor buttons to select the Go to Advanced Menu..., and use
the ► cursor button to enter the item.
4) Use the ▲/▼ cursor buttons to select the NETWORK, and use the ► cursor
button to enter the item.
5) Use the ▲/▼ cursor buttons to select the INFORMATION, and use the ►
cursor button to display the INFORMATION.
6) The Passcode appears in the INFORMATION window.
Method 2
• Take the method 2 when you project your computer image by the
“LiveViewer”, or when the LAN port is not selected as input source.
•
If no communication between the projector and computer in 5 minutes, the
Passcode will be changed.
NOTE
1. Connection to the network
1.5 Selecting the network connection method (continued)
To Next Page
Loading...
