Need help?Do you have a question about the Hitachi DH 40MR and is the answer not in the manual?
General| Drilling Capacity in Concrete | 40 mm |
|---|---|
| Drilling Capacity in Steel | 13 mm |
| Drilling Capacity in Wood | 32 mm |
| Vibration Control | Yes |
| Cord Length | 2.5 m |
| Chuck Type | SDS Plus |
| Full Load Impact Rate | 4150 bpm |
| Power Consumption | 1100W |
Ensure clean, well-lit workplace and keep unauthorized persons away.
Proper plug use, avoid grounding, keep away from rain/wet conditions, handle cords carefully.
Stay alert, use safety equipment, avoid accidental starting, dress properly.
Use correctly, maintain tools, store safely, and keep sharp.
Ensure proper maintenance and service by qualified personnel.
Accessories for drilling holes through materials.
Accessories for drilling anchor holes.
Accessories for boring large diameter holes.
Step-by-step guide for drilling holes using the tool.
Instructions for using the tool for chiseling or crushing.
Procedure for drilling with combined rotation and hammering.
Steps to switch the tool to hammering mode.
Adjusting the tool's working direction and position.
How to attach and secure the depth stopper.
Procedure for warming up the tool in cold regions.
Steps for drilling and driving anchors with a taper shank adapter.
Procedure for switching the tool mode.
Steps to attach the chuck adapter to the drill chuck.
Guidelines for drilling operations with accessories.
Steps for mounting the core bit and related parts.
Procedure for drilling holes using a core bit.
Steps to safely remove the core bit.
Recommended schedule for grease replacement.
Procedure for adding new grease to the tool.
Regular checks for tool condition and sharpness.
Ensuring all mounting screws are properly tightened.
Care for the motor unit winding to prevent damage.
Checking and replacing carbon brushes.
Steps for replacing worn carbon brushes.
Procedure for replacing the power supply cord.
Applications for drilling concrete.
Applications for drilling anchor holes.
Applications using optional accessories for demolition and shaping.
Ensure power source conforms to tool requirements.
Ensure power switch is OFF before plugging in.
Use appropriate extension cord of sufficient thickness and capacity.
Step-by-step guide for installing tools like bull points and chisels.
To Next Page
