2
b) Use power tools only with specifi cally
designated battery packs.
Use of any other battery packs may create a risk of
injury and fi re.
c) When battery pack is not in use, keep it away
from other metal objects like paper clips,
coins, keys, nails, screws, or other small metal
objects that can make a connection from one
terminal to another.
Shorting the battery terminals together may cause
burns or a fi re.
d) Under abusive conditions, liquid may be
ejected from the battery; avoid contact. If
contact accidentally occurs, fl ush with water. If
liquid contacts eyes, additionally seek medical
help.
Liquid ejected from the battery may cause irritation
or burns.
6) Service
a) Have your power tool serviced by a qualifi ed
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool is
maintained.
PRECAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach
of children and infi rm persons.
PRECAUTIONS FOR CORDLESS DRIVER DRILL
1. Always charge the battery at a temperature of 10 –
40°C. A temperature of less than 10°C will result in over
charging which is dangerous. The battery cannot be
charged at a temperature higher than 40°C.
The most suitable temperature for charging is that of 20
– 25°C.
2. When
one charging is completed, leave the charger for
about 15 minutes before the next charging of battery.
Do not charge more than two batteries consecutively.
3. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
4. Never disassemble the rechargeable battery and
charger.
5. Never short-circuit the
rechargeable battery. Short-
circuiting the battery will cause a great electric current
and overheat. It results in burn or damage to the battery.
6. Do not dispose of the battery in fi re.
If the battery is burnt, it may explode.
7. When drilling in wall, fl oor or ceiling, check for buried
electric
power cord, etc.
8. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use. Do not dispose of
the exhausted battery.
9. Using an exhausted battery will damage the charger.
10. Do not insert object into the air
ventilation slots of the
charger.
Inserting metal objects or infl ammables into the charger
air ventilation slots will result in electrical shock hazard
or damaged charger.
11. When mounting a bit into the keyless chuck, tighten the
sleeve adequately. If the sleeve is not tight, the bit may
slip or fall
out, causing injury.
SPECIFICATIONS
POWER TOOL
Model DS12DVF
No-load speed (Low/High) 0 – 350 / 0 – 1050 / min
Capacity
Drilling
Wood
(Thickness 18 mm)
21 mm
Metal
(Thickness 1.6 mm)
Steel: 12 mm,
Aluminum: 15 mm
Driving
Machine screw 6 mm
Wood screw
5.5 mm (diameter) × 63 mm (length)
(Requires a pilot hole)
Rechargeable battery
BCC1212: Ni-Cd 12 V (1.2 Ah, 10 cells)
Weight 1.5 kg
CHARGER
Model UC18YK
Charging time Approx. 50 min. (at 20°C)
Charging voltage 12 V
Weight 0.35 kg
STANDARD ACCESSORIES
DS12DVF
1 Plus driver bit (No. 2 × 55L) .................. 1
2 Charger (UC18YK) ................................ 1
3 Plastic case ..........................................1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (BCC1212)
Optional accessories are subject to change without notice.
To Next Page
Loading...
Need help?
General
