English
13
<UC24YJ for DS18DMR> <UC18YG for DS14DMR, DS18DMR>
Model DS14DMR DS18DMR
Motor DC motor
No-load speed Low 0–400/min 0–400/min
High 0–1,500/min 0–1,600/min
Capacity Drilling
Wood (Thickness
1-3/4"
(44 mm)
2" (50 mm)
11/16" (18 mm)) (Soft Wood) (Soft Wood)
Metal (Thickness
1/2" (13 mm) 1/2" (13 mm)
1/16" (1.6 mm)) (Mild Steel or (Mild Steel or
Aluminum) Aluminum)
Screw Wood screw #20 × 3" #20 × 4"
Driver
(8 mm × 75 mm) (8 mm × 100 mm)
Small screw 1/4" (6 mm) 1/4" (6 mm)
Drill chuck capacity Maximum gripping diameter 1/2" (13 mm)
Battery Model EB14B EB1820L EB1830HL
Type
Nickel cadmium battery
Nickel-Metal Hydride battery
Voltage DC 14.4 V DC 18 V
Charging & discharging UC14YFA /UC24YJ....................about 1,000 times
frequency UC18YG ........................................about 300 times
Weight 5.1 lbs. (2.3 kg) 5.5 lbs. (2.5 kg)
SPECIFICATIONS
1. Cordless Driver Drill
Fig. 4Fig. 3
Charge Time Lamp
Charge
Status Lamp
Caution Plate
Nameplate
Battery Installation Hole
Battery installation hole
Pilot lamp
Cord
Plug
Nameplate
2. Battery Charger
NOTE: The charging time may vary according to temperature and power source voltage.
Model UC14YFA UC24YJ UC18YG
Input power source Single phase: AC 120 V 60 Hz
Charging time Approx. 50 min. Approx. 28min. Approx. 50min.
(At a temperature of 68°F (20°C))
Charging voltage DC 7.2–14.4 V DC 7.2–24 V DC 7.2–18 V
Charging current DC 2.6 A DC 7.5 A DC 2.6 A
Weight 1.3 lbs. (0.6 kg) 2.2 lbs. (1.0 kg) 0.7 lbs. (0.3 kg)
To Next Page
Loading...
Need help?
General