--- 7 ---
OIL GAUGE CAP
Feed oil, before oil is invisible
in the oil gauge by holding the
body upright.
7. PRECAUTIONS IN SALES PROMOTION
In the interest of promoting the safest and most efficient use of the Model H 65SC Electric Hammer by all of our
customers, it is very important that at the time of sale the salesperson carefully ensures that the buyer seriously
recognizes the importance of the contents of the Handling Instructions, and fully understands the meaning of the
precautions listed on the Caution Plate attached to each tool.
7-1. Handling Instructions
Although every effort is made in each step of design, manufacture and inspection to provide protection against
safety hazards, the dangers inherent in the use of any electric tool cannot be completely eliminated. Accordingly,
general precautions and suggestions for the use of electric power tools, and specific precautions and suggestions
for the use of the Electric Hammer are listed in the Handling Instructions to enhance the safe, efficient use of the
tool by the customer. Salespersons must be thoroughly familiar with the contents of the Handling Instructions to
be able to offer appropriate guidance to the customer during sales promotion.
7-2. Caution Plate
Each Model H 65SC unit is provided with a Caution Plate (illustrated below) which lists basic safety precautions in
its use. Carefully ensure that the customer fully understands and follows these precautions before using the tool.
For the U.S.A. and Canada
Cautions on Oil Gauge:
-- WARNING -- To reduce the
risk of injury,
user must read and understand instruction manual.
AVERTISSEMENT Afin de rèduire le risque de
blessures, l'utilisateur doit lire et
bien comprendre le mode d'emploi.
Hitachi Koki
7-3. Oil Supply
As the Model H 65SC is equipped with a built-in oil tank, there is no need for manual oiling of the tool prior to and
during operation.
To prevent possible oil staining of the steel carrying case during shipping, only approximately 10 cc of oil is
supplied to the oil tank when the tool is shipped from the factory. Accordingly, it is very important that the
customer be instructed to remove the Oil Gauge and fill the oil tank with the standard accessory oil at the
time of purchase.
If lubricant for high-speed rotating and sliding parts
such as the needle bearings, piston, etc. is depleted,
it could cause damage such as jamming of sliding
parts, early damage, etc.
To Next Page
Loading...
