Hitachi PC-ARH1E - Setting Method Overview

5.4 SETTING METHOD
5.4.1 Temperature Setting
• Bypressing“Temp˄”,thetemperatureisincreasedby
0.5°C (Max. 30°C).
• Bypressing“˅Temp”,thetemperatureisdecreasedby
0.5°C.
• Cooling,Dry,Airowoperation:Min.19°C
• Heating operation: Min. 17°C
? NOTE
Minimumand maximumtemperature levelscanbe adjustedby setting
the lower limit (set temperature for cooling) and the upper limit (set
temperatureforheating)fromthefunctionselection.
5.4.2 Fan Speed
By pressing “Fan”, the fan speed will be adjusted as follows.
LOW
MEDIUM
HIGH
HIGH2
AUTO
? NOTE
• During the dry operation, the fan speed is automatically adjusted
to “LOW” and cannot bechanged to another fanspeed. (“LOW ”
willNOTbedisplayedontheLCD(liquidcrystaldisplay)atthistime.
ThepresentsettingconditionwillbedisplayedontheLCD.)
• The fan speed settings “HIGH2” and (or) “AUTO” might not be
availabledependingonthetypeofindoorunit.
5.4.3 Swing Louver Direction
By pressing “Louver”, the louver direction will be adjusted as
follows.
LCD Indication
COOL,
DRY
Auto-Swing
HEAT,
FAN
Recommended
angle
Angle
range
Recommended
angle
Angle
range
: The Auto-swing operation will start. At this time, the
louver graphic will swing repeatedly on the LCD display.
? NOTE
• The airow angle is different for each indoor unit type. Check for
detailed information in “Swing Louver Direction” of each operation
manualforindoorunit.
• Louveraction as depictedonthe LCDdisplay mightnotmimicthe
actual movement of the louver during the auto-swing operation.
Toadjustlouverposition,rstsetthe angle newangleontheLCD
display.
• Louveractionmightnotstopimmediatelyaftertheswitchispressed.
OPERATION
PMML0497 rev.1 - 12/2020
6