--- 12 ---
Fig. 8
Bottom of the housing
(7) Connect the internal wires of Stator (A) [10] correctly as shown in Fig. 8 and Fig. 9.
(8) Connect each internal wire correctly as shown in Fig. 9 being careful not to put them between the parts.
Brush Holder [40]
Internal wire from Cord [54]
Machine Screw (W/Washer) M3.5 x 6 [48]
Guide plate
Machine Screw (W/Washer) M3.5 x 6 [48]
Switch (1P Screw Type) [49]
: Tail Cover (A) [35]
Internal wire from Stator (A) [10]
Internal wire from Noise Suppressor [45]
Fig. 9
Internal wire coming from
the Noise Suppressor [45]
Insert the terminal securely then push
and fold the terminal toward the outside
of the housing as much as possible.
(9) When replacing the Gear Cover Ass'y [3], lubricate the needle bearing part with mixed oil.
Mixed oil: A mixture of Hitachi Power Tool Grease No. 2 (Unilube No. 00 Code No. 939302 is recommended)
and turbine oil
Mixture ratio ......... 1:1 (weight ratio) Quantity ........... 0.5 cc
OFF side
ON side
To Next Page
Loading...
