RAS-
RAS-
Temporary Switch
Non-conductor Stick
Press
about 7mm
COOLING UNIT INDICATORS
TEMPORARY SWITCH
Use this switch to start and stop when the remote
controller does not work. [Use non-conductor stick
(example toothpick)]
● By pressing the temporary switch, the operation is
done in previously set operation mode.
● When the operation is done using the temporary switch
after the power source is turned off and turn on again,
the operation is done in automatic mode.
POWER SWITCH
OPERATION INDICATOR
OPERATION LAMP
This lamp lights during operation.
TIMER LAMP
This lamp lights when the timer is working.
SIGNAL RECEIVER
There will be a beep sound when this receiver receive
signal from remote controller.
– 8 –
To Next Page
Loading...
Need help?
General
