Hitachi RAC-10JH5 - FILTER INSTALLATION AND VERIFICATION; Opening the Front Panel; Removing the Pre-Filter; Removing the Air Purifying Unit

– 11 –
Open the Front Panel
Ŗ Hold both sides of the front panel and lift up.
Removing the Pre-Filter
Ŗ Pull out the pre-filters on the right and left.
Removing the Air Purifying Unit
Ŗ Remove the air purifying unit (2 pieces) by pulling
out while pushing up with both hands.
Attaching the Wasabi-Nano Air Purifying
Filter on the Air Purifying Unit
Ŗ Open the air purifying unit and attach the
wasabi-nano air purifying filter with the jagged
side up.
Attaching the Air Purifying Unit
Attaching the Pre-Filter
Ŗ Please attach the pre-filter with the “FRONT”
indication. (The configuration of the left and right
pre-filters is different.)
1
4
2 3
5
6
Please install the filters after turning off the device with the remote controller.
INSTALLING AND VERIFYING THE WASABI-NANO AIR PURIFYING FILTER/DUCT
FILTER (FRESH DEODORIZING/DUST COLLECTING FRESH AIR IN FILTER)
Ŗ This filter can be used for about 2 years. Please
do not wash this filter. This filter is disposable
type.
Wasabi-Nano
Air Purifying Filter
(Included)
Air Purifying Unit
Air Purifying Unit
Front Panel
Pre-Filter
1
Push and Lift
2
Pull Out
Air Purifying Unit
1
Insert
2
Insert
Pre-Filter
1
HSILGNE