– 20 –
SELF CLEAN OPERATION
To cancel, press the button again.
Ŗ The button on the remote controller turns off.
Ŗ The “SELF CLEAN” lamp on the indoor unit indicators turns off.
Press the button.
Ŗ The device beeps when it has received the signal and the button
on the remote controller turns on.
Ŗ The “SELF CLEAN” lamp on the indoor unit indicators turns on.
Ŗ This operates for about one hour and automatically stops.
Ŗ The “OPERATION” lamp on the indoor unit indicators turns on during the self
clean operation and then the “SELF CLEAN” lamp blinks. (When drying the
two way air exchange fan and hose operation is performed, the “TWO WAY
AIR EXCHANGE” lamp also turns on.)
Ŗ When cooling and dehumidifying operation are performed for a short time (less
than 1 hr.), the Self Clean operation does not perform.
(Please refer to page 3 , Understanding The Operating Mechanism)
Ŗ By configuring Self Clean operation, once cooling and dehumidifying operation are performed, the device
automatically performs Self Clean operation suppressing the outbreak of mold. (This does not eliminate the
presence of mold or have a bactericidal effect.)
Ŗ As this operation cause the two way air exchange fan and hose dry, it is recommended that to set Self Clean
operation when utilizing the fresh air in operation (Refer page 21).
6
TO SET SELF CLEAN OPERATION
1
To Next Page
Loading...
